(EN)

PATIO HEATERS

PURLINE

 

PACHA 10 MODEL

PACHA 20 MODEL

 

 

 

 

User Manual

WinEurope -  FRANCE

E-mail: info@purline.com                                                                                                          

Web:   www.purline.com

SPECIFICATIONS

 

 

models

 

 

color

 

voltage

 

input power

 

height

 

type

PACHA10

STAINLESS STEEL

220-240V

2000-2400W

1.1 M

FIXED

PACHA20

STAINLESS STEEL

220-240V

2000-2400W

2.0 M

FIXED

 

USER INSTRUCTIONS

CAUTION:

1.      Read this manual attentively before assembling.

2.      IMPORTANT: ensure that the various parts of the device are closely attached to each other once the assembly is complete and before turning the device on.

3.      Ensure that your voltage corresponds to the supply voltage required by this device (AC 220-240V ~ 50Hz).  See the rating plate affixed to the device. Also, make sure the device is grounded. To be used outdoors, the plug and earth electrode must be waterproof. The circuit power must be equal or higher to 13 amperes.

4.      To reduce the risk of fire or electrocution, the device's plug must perfectly match the wall connection plug.
If the electrical cable or the plug are damaged, have them repaired by the reseller, an after-sales service, or a qualified technician to avoid possible risks.

5.      The device must always remain on a flat and stable surface whether indoors or outdoors.

6.      Do not touch or move the device while it is on to avoid burns.

7.      We remind you that you the plug for this device must be waterproof.  The same applies to the wall outlet.

8.      Outdoors, do not place the device near a pool or body of water.

9.      Carefully unwind the electrical cord and ensure that it does not touch the device. Never place the device under an electrical outlet.

10. Do not use this device with a programmer or any device that automatically turns the heat on; this could cause a fire if the device is poorly positioned or covered.

11. The fireguard is intended to prevent direct access to the heating elements and must be in place when the heater is on. This fireguard may not suffice to protect children or disabled persons.

12. Do not place this device close to curtains or flammable gases or materials. Fire hazard.

13. Do not place the device close to a person taking a shower or bath. Risk of electrical shocks.

14. This heating device should not be used by children or disabled persons.

15.  Never install the device in a bathroom as it could fall into a bathtub filled with water, for example. Also, never place it close to a sink, pond or pool. NEVER PUT THE HEATER under water.

16. When the device is not in use, store it indoors.

 

* IF YOU MUST USE AN EXTENSION CORD, PLEASE INSURE TO FOLLOW SAFETY REGULATIONS CORD MUST BE AN APPROVED OUTDOOR CORD (1.5mm wiring and preassembled plugs).

WARNING

Once activated, the tube above this label is HOT.

DO NOT hold this tube above this label to move!

Risk of fire exist if this heater is covered, or positioned too close to curtains or other combustible materials.

Keep AWAY from combustible materials

 

REMINDER:

-         Do not allow children to use the device.

-         Do not place other heating sources close to the device when it is on.

-         Ensure that your electrical circuit is adapted to a 13 Ampere device.

 

ASSEMBLY

CAUTION: For safety reasons, carefully assemble the device as set out below and make sure the heating element, tubes and base are tightly fitted, then bolted to each other.

 

1 : Assembly to the heating element

 

Remove all of the parts from the box and place them so that they are within reach during the assembly. See Figure 1 below.

The electrical cable attached to the heating element must be inserted through the inside of the tube section corresponding to the heating element.  The heating element must be turned over and remain stable.  Gently turn the tube in its setting on the heating element without attaching it for the time being.

 

 

Figure 1                                                                                                 

2 : Base Assembly

As indicated in the figure below, pass the electrical cable from the base inside the tube section (corresponding to the base).  Turn the base over.  It must remain stable. Turn the tube in its setting.  Tighten it, but do not attach it yet.

Figure 2                                                                                                 


3: Assembly of the Third Section of the Tube

Pass the electrical cable coming from the base through the third section of the tube.  Attach this section to the section already attached to the base, without screwing it on for the time being.

 

Figure 3                                                                                                

 

4 : Complete Assembly and Attaching

The base is in a vertical position.  Plug the two sections of the electrical cable together. Ensure that the device is stable.  Tightly screw the sections together.

 

 

Figure 4                                                                                          


DESCRIPTION:

Heating base                              Protective cover

Reflective shield                          Cover base

Shield base                                Heater

Protective net                             Holding tube

       Wheels   Switch    Base       Electrical cable

 

USER PRECAUTIONS:

  1. This device is to be used only to raise local temperatures in a defined location.
  2. Do not leave flammable items, such as paper, clothes, etc., close to the device.
  3. Do not touch the cover or protective grill of the heating unit when the device is on.  The temperature is high and you may burn yourself!
  4. When the device is turned on, it will take some time to start heating.

 

OPERATIONS:

-         The switch is located under the base of the device:

-         O …. Off

-         I …. On

 

  1. Assemble the device as described above.
  2. Plug it into a waterproof outlet after having verified that the voltage corresponds to the indicated voltage.
  3. Press the On button.

 

MAINTENANCE:

  1. Turn the device off and unplug it. If the device was on before cleaning, wait until it has cooled down so you do not burn yourself.
  2. With a soft cloth, carefully clean the device. Never use alcohol, solvents or acids such as vinegar or abrasives.

 

TROUBLESHOOTING:

Issues

Potential causes

Solutions

The device will not turn on.

The device is not plugged in properly.

Remove the plug and plug it in again properly.

 

The plug is defective.

Have it replaced by a electrician.

The device does not work, but the current passes through.

An object is preventing the On/Off button from working properly.

Place it on a flat and stable service.  Look for the object to be removed.

The device functions, then suddenly stops functioning.

Verify your electrical power system/fuse/circuit breaker.

Have it checked by an electrician.

 

ELECTRICAL DIAGRAM

 

WARRANTY:

Two years from the date of purchase.

To use the warranty, please bring or send (PREPAID) the device to your reseller along with the proof of sale indicating the purchase date.

Removal of used domestic appliances
European directive 2002/96/EC on the Electric and Electronic Equipment Waste requires that domestic appliances not be thrown out together with the rest of municipal waste. Used devices must be collected separately in order to optimize recuperation and recycling rates of the materials that make them up and so reduce the impact on human health and the environment.
The symbol of the crossed out garbage can appears on all the products to remind the obligations regarding separated collection.
Consumers must contact local authorities or resellers regarding the procedure to follow for the device's removal.

 

 

WARNING

 

Once activated, the tube above this label is HOT.

DO NOT hold this tube above this label to move!

Risks of fire exist if this heater is covered, or positioned too close to curtains or other combustible materials.

Keep AWAY from combustible materials.