CERAMIC TOWER HEATER

With remote control

Pur Line

MODEL

CHS185T

WinEurope - FRANCE

email : info@purline.com

Internet : www.purline.com

IMPORTANT SAFETY INSTRUCTIONS

Read all instructions before using heater

1. This heater is hot when in use. To avoid burns, do not have let bare skin touch hot surfaces. Always use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9m) away from the front of the heater and keep them at least 1 feet (0.3m) away from the sides and rear.

2. Extreme caution is necessary when heater is used. .

3. Always unplug heater when not in use.

4. Do not operate heater if the cord or plug are damaged, or

after the heater malfunctions, has been dropped or damaged in any manner. Return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.

5. Do not use outdoors.

6. This heater is not intended for use in wet or damp locations. Never locate heater where it may fall into a bathtub or other water container.

7. Do not run cord under carpeting. Do not cover

cord with throw rugs, runners, or the like. Arrange cord away from traffic area and where it will not be tripped over.

8. To disconnect heater, turn switches to off position, then remove plug from outlet. Pull only by the plug. Do not pull on the cord when disconnecting it.

9. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.

10. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like bed, where openings may become blocked.

11. A heater is hot and as arcing or sparking parts inside. Do not use it in area where gasoline, paint, or flammable liquids are used or stored.

12. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.

13. Do not use an extension cord it could overheat and cause a fire.

14. This heater is for residential use only. It is not intended to be use in commercial or industrial settings.

OPERATING INSTRUCTIONS

CONTROL PANEL :

1- When the heater is plugged in, push the power switch at the rear of the base to “—“ there will be a beep to indicate that there is power to the unit.

2- Power Button : press this button once, the LCD will display the current mode. Press it again, the unit will stop running.

3- Mode Button : press this button once the LCD will display “HIGH” indicating that the heater is in high heat mode. It shows the ambient temperature as well.

4- Press Mode Button again, the LCD will display” LOW”, indicating that the heater is in LOW heat mode, it also shows the ambient temperature.

5- Press Mode a third time, the LCD will display AUTO, indicating that the heater is in automatic control mode. Press +/- to set required temperature. + indicates higher temperatures, the highest temperature is 30°C. – is for lower temperature, the lowest temperature is 15°C. To add one (1°) more degree press + once. Keep pressing until you obtain the desired temperature. If the TEMP Button (+/-) is not pressed within 10 seconds, the display will stop blinking SET TEMP and change to ROOM TEMP.

6- TIMER BUTTON: Press it once, the LCD will show that the heater will run for one hour , press it twice it will run for two hours and so on, up to 8 hours. If you press a ninth time the LCD display goes off, the heater then runs continuously. The time setting changes from 1 till 8 and off when this button is kept pressing.

7- O S C Button : Press this button once, the heater will oscillate back and forth a full 120 degrees. Press it again the oscillation will stop. The heater does not oscillate when it is set in AUTO mode, it only oscillates in HIGH or LOW mode.

8- The heater must be placed FLAT on an even and horizontal surface or the tip-over switch will shut if off automatically.

CONTROLS

figure 3

REMOTE CONTROL

The remote control functions are the same as the buttons on the control panel, stated in above instruction steps 1 to 7. It is powered by two AAA batteries.
There is a cover on the back of the remote control that can be removed for replacement of the batteries as required.

MAINTENANCE

CLEANING :

Clean the filter net at least monthly or more often if dirty. A dirty filter could restrict the air flow and cause the heater to function improperly or shut down. Do not attempt to remove inlet grill from the heater.

a) Unplug heater from power source.

b) Vacuum rear grill area of heater with vacuum cleaner brush attachment to remove lint and dirt from internal filter (see Figure 5).

c) Clean the body with a soft cloth. Never use alcohol or solvents.

STORAGE: Store the heater with these instructions in the original box in a dry place.

SAFETY FEATURES

1. A tip-over switch is built in to prevent operation if the heater is tipped over.

2. A thermal overload protector and a thermal fuse are built in to prevent overheating.

3.An in-line fuse is built in to prevent operation in the event of overload

ELECTRICAL RATING

This product is rated 8 Amps (1800 Watts) at 220-240V ~ 50Hz.

Note: There are no consumer serviceable parts inside this heater.

If you experience a problem, please see warranty for information.

Please do not attempt to open the heater yourself, doing so will void your warranty and could cause damage and personal injury.

TECHNICAL SPECIFICATIONS

Dimensions : L 21.2 x D 23.0 x H 54 cm

Net weight : 3.5 Kg

Voltage : 220 / 240 V

Absorbed power : 1100 W and 1800 W

UPC / EAN 3 700046510699

Warranty : 1 year to first buyer.

To insure of rights to warranty privileges, please insure to include with claim your proof of purchase showing purchase date.